![]() Wrap each wire around itself at least six times. Be sure the mast remains vertical during this procedure. Run the screw eye ends of the wires through the eyes and pull the wires equally taut. After the guy wires are installed, cover each screw eye with roofing tar.Īttach fully-extended turnbuckles to guy wires about a foot from each screw eye (Figure 3). Be sure each screw eye is firmly anchored in solid wood at least five feet from the base of the mast. If four guy wires are used, they should be anchored in screw eyes 90° apart. Ideally, the guy wires should extend out from the mast at a 45° angle, and should be anchored in screw eyes placed 120° apart (Figure 2). The wire then is wrapped around itself at least six times (Figure 1). The mast ends of the guy wires are run through holes in the guy ring. ![]() The ring and clamp are fitted to the mast before the antenna is attached. The guy wires are attached to the upper half of each mast section with a guy ring and clamp. This will give the extra strength required for most installations. Telescoping masts generally require 4 guy wires for each 10 foot section. Standard antenna masts (10 feet in height) require only one set of three guy wires. Six-strand 18 or 20 gauge galvanized steel guy wire is recommended for general use(The 18 gauge wire is recommended for high-wind areas and installations over 20 ft. The materials needed for a standard guy wire installation are: guy wires, guy ring(s), screw eye, and turnbuckles. However, only the best quality materials and careful installation will provide sturdy, safe, long-lasting support. The correct installation procedure is relatively simple. Consistent, safe support of antenna installations over 10 feet above the uppermost wall bracket or roof mount depend on how well the guy wires are installed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |